How double progression works

Every lift has a rep range, usually 6 to 10. You take one set to failure at a fixed weight. While your reps are inside the range, the weight stays put and the job is to beat last time by a rep.

When you reach the top of the range, the weight goes up by the smallest step your equipment allows and you start again near the bottom. Reps first, then load. That is the whole method, and it means every increase is earned by a set you actually did.

The five verdicts

  • Set your baseline. No set logged yet. Warm up and take one set to failure inside the range. That is the number to beat.
  • Add a rep. You landed inside the range. Same weight next time, one more rep.
  • Add weight. You reached the top of the range. Add one step and aim for the bottom of the range or more.
  • Rest longer. You matched or fell short of the session before. Keep the weight and take more rest before this lift comes round again. The rest day calculator works out how much.
  • Drop the weight. You fell below the range. The calculator back-solves a lighter load from your set with the Epley formula, rounded down to your step. That rule is ours, not Mentzer's.

A worked example

Five sessions of leg press in a 6–10 range, on a machine that steps in 5 kg. Each row is what was lifted and what the calculator says to do next.

Session 5 only repeats session 4. At 145 kg you are still inside the range, so the calculator reads it as a recovery problem: same weight, more rest, then go for 8.

Why one set

Mentzer argued that one all-out set gives the muscle the reason to grow, and every extra set eats into the recovery that growth needs. In Heavy Duty II he set 6 to 10 strict reps as a guideline, with a few exceptions: 1 to 3 on inclines, 3 to 5 on dips, 12 to 20 on calves. The calculator uses those ranges for its presets.

The range is a guide for choosing the weight. He was clear that you don't stop a set because you hit the number: you go until no further full rep is possible, and the count tells you what to do next session. More on that in one set to failure.

The Failure Point app will run this calculation after every set you log, once it launches in 2027.